| |
Buck/Boost Transformer with premolded plug and receptacle. Unlike traditional transformers, you don't have to wire this one. It is designed to plug any 15 or 20 amp tanning bed in (NEMA 6-15 or 6-20) and you just plug it into your dedicated circuit (NEMA 6-20).
PLEASE NOTE: Your actually running voltage will be LESS than this measured voltage using a digital volt meter because voltage usually drops a small amount under load. We recommend that you buy a buckboost transformer with the goal of achieving 130 to 135VAC using your unloaded measurement for best performance.
This unit will raise the incoming voltage by approximately 16 volts AC. For most tanning beds that need 230v, this is the correct transformer if your incoming voltage (as measured using a digital volt meter) is 210VAC to 219VAC.
|
Worried about lamp breakage? We have you covered.
In the event of damage during shipping, we will replace or refund the damaged lamps. Please accept the shipment, note the damage to the carrier, and call us. Fortunately, damage is rare, but we have you covered regardless. Just call us during normal business hours, east coast time, at 1-800-274-1744. You will NOT have to file any paperwork with the carrier or deal with them at all. We handle everything, and can usually fix the issue on your first phone call to us.
We now have a minimum purchase of 14 lamps. If the website isn't allowing you to mix and match properly, just call us at 1-800-274-1744 to place your order. |
|